New heads! no more old tired dogs. had to port them to match the intake.
- My poor truck, ran so good b4 I fubared it
finally sliding it all together 12/26/09
Short block! finally!
need a final porting and maybe a trip to the machine shop to put a few more angles on the valve seats
Intake ports needed to be opened up they were choking my poor engine
CHOP CHOP!
here is what killed my ride!
goodbye 37.5 hello 45 seat angle
Improving air flow with a SERDI valve seat machine
lifter plunger bottomed out
adjustablr pushrod to aide in checking lift at valve
flash makes gauge unreadable but the diesel only has .384 worth of valve lift
super clean turbo oil drain. Thanks AMSOIL!
No burnt oil here! all clean and ready for service!
Almost finished! cant wait!
all exhaust and turbo ceramic coated
03/03/10
Ok 912 miles and I decided after 120 mile round trip to pull an oil sample and here was the results of that…
CLEVELAND_TECHNICAL_CENTER-I797442-Sev1
Pingback: What did you do to your IDI today? - Page 17 - Diesel Forum - TheDieselStop.com
Pingback: Crank no start turns into seized - Page 3 - Diesel Forum - TheDieselStop.com